by admin | May 21, 2024 | Tech Tip
A project across the bench this week, soldering terminals to hub motor stators and extending the hall sensor wiring.Another great use for high-temperature lacing cord and polyamide (kapton) tape.
by admin | Feb 18, 2023 | Tech Tip
These pre-made PCBs fit the 10-way Grayhill and Elma Rotary switches that have PCB pins. Featuring aString of 1K resistors, with optional top and tail resistors to stop hard connection to the supply rails. Easysolution for an evenly spaced ratiometric output and a lot...
by admin | Feb 2, 2023 | Tech Tip
If you run a steering wheel with a Krontec QR earlier than 2018, check it has the steel spacer ringinstalled. Early Krontec QR’s did not have this included. The Autosport Connector was only retained by agrub screw and could get pushed back over time, resulting in...
by admin | Jan 28, 2023 | Tech Tip
Technically the carbon on this LMP2 should be a good ground plane for the 1⁄4 wave Radio VHF antenna. Unfortunately, the resin and poor bite into the material often lead to a fairly average ground plane. Adding a copper or aluminum foil ground plane can really help...
